OpenSips configuration
Revision as of 15:48, 29 March 2024 by Admin (talk | contribs) (Created page with " <pre> dnf config-manager --set-enabled crb dnf install epel-release epel-next-release dnf install https://yum.opensips.org/3.4/releases/st/9/x86_64/opensips-yum-releases-3.4-6.el9.noarch.rpm yum install opensips opensips-* opensips-cli socat systemctl enable opensips </pre> copy the file from /var/www/html/pbx/protected/opensips.conf to /etc/opensips/ OpenSIPS will listen to port 5067 and connect to Asterisk PJSIP stack on port 5091 Change <IP-SERVER>,<NAT-IP-SERVER...")
dnf config-manager --set-enabled crb dnf install epel-release epel-next-release dnf install https://yum.opensips.org/3.4/releases/st/9/x86_64/opensips-yum-releases-3.4-6.el9.noarch.rpm yum install opensips opensips-* opensips-cli socat systemctl enable opensips
copy the file from /var/www/html/pbx/protected/opensips.conf to /etc/opensips/
OpenSIPS will listen to port 5067 and connect to Asterisk PJSIP stack on port 5091
Change <IP-SERVER>,<NAT-IP-SERVER>,<IP-ASTERISK>, <DOMAIN-ASTERISK> to your data
<IP-SERVER> - ip address your VM
<NAT-IP-SERVER> - if used NAT, set real ip. If not, set same as <IP-SERVER>
<IP-ASTERISK> - ip address for the asterisk server
<DOMAIN-ASTERISK> - FQDN for the asterisk server