Enabling WebRTC: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| (4 intermediate revisions by the same user not shown) | |||
| Line 16: | Line 16: | ||
The tlscertfile needs to point to your certificate in pem format | The tlscertfile needs to point to your certificate in pem format | ||
You can provide separate cert and key: | |||
<pre> | |||
tlscertfile=/etc/ssl/demo.mirtapbx.com.crt | |||
tlsprivatekey=/etc/ssl/demo.mirtapbx.com.key | |||
</pre> | |||
It may be needed to set the following parameters in sip.conf too: | |||
<pre> | |||
dtlsenable=yes | |||
dtlsverify=fingerprint | |||
dtlscertfile= | |||
dtlsprivatekey= | |||
</pre> | |||
* Activate the ws and wss transport in sip.conf, set the realm | * Activate the ws and wss transport in sip.conf, set the realm | ||
<pre> | <pre> | ||
transport=udp,tls,ws,wss | transport=udp,tcp,tls,ws,wss | ||
realm=demo.mirtapbx.com | realm=demo.mirtapbx.com | ||
</pre> | </pre> | ||
* Set the path for your certificate in the Web interface - Admin/Settings, Security section, WebRTC SSL path field | * Set the path for your certificate in the Web interface - Admin/Settings, Security section, WebRTC SSL path field | ||
* In your extension enable Opus Codec, RTP Encryption and Any Transport | * In your extension enable Opus Codec, WebRTC support, RTP Encryption and Any Transport | ||
== Verifying WebRTC == | == Verifying WebRTC == | ||
| Line 32: | Line 48: | ||
[[File:sipML5.png|400px]] | [[File:sipML5.png|400px]] | ||
Latest revision as of 20:31, 1 December 2020
WebRTC is not enabled by default and you need to follow carefully the following steps to make it work.
- Install an SSL certificate on Asterisk. This needs to be a real SSL certificate. Check the Asterisk FAQ on how to install an SSL Certificate in Asterisk
- Install the Opus codec and add to the web interface. You can check the instructions in the Setup Guides section Installing OPUS codec
- Activate the http daemon for asterisk by editing the http.conf file as following:
[general] enabled=yes bindaddr=0.0.0.0 bindport=8088 tlsenable=yes tlsbindaddr=0.0.0.0:8089 tlscertfile=/etc/asterisk/certificates/demo.mirtapbx.com.pem
The tlscertfile needs to point to your certificate in pem format
You can provide separate cert and key:
tlscertfile=/etc/ssl/demo.mirtapbx.com.crt tlsprivatekey=/etc/ssl/demo.mirtapbx.com.key
It may be needed to set the following parameters in sip.conf too:
dtlsenable=yes dtlsverify=fingerprint dtlscertfile= dtlsprivatekey=
- Activate the ws and wss transport in sip.conf, set the realm
transport=udp,tcp,tls,ws,wss realm=demo.mirtapbx.com
- Set the path for your certificate in the Web interface - Admin/Settings, Security section, WebRTC SSL path field
- In your extension enable Opus Codec, WebRTC support, RTP Encryption and Any Transport
Verifying WebRTC
To verify the WebRTC configuration, you can try to register and place calls using the SipML5 by visiting: https://www.doubango.org/sipml5/
