Admin at 21:57, 20 September 2018

2018-09-20T21:57:18Z

← Older revision		Revision as of 21:57, 20 September 2018
Line 3:		Line 3:
	The Asterisk application is quite simple and integrating it in a Multitenant PBX was not easy. Unfortunately, the configuration cannot be made from the tenant or maybe, I don't like to have the tenant to mess with this, so the configuration is reserved for the Admin, for now.		The Asterisk application is quite simple and integrating it in a Multitenant PBX was not easy. Unfortunately, the configuration cannot be made from the tenant or maybe, I don't like to have the tenant to mess with this, so the configuration is reserved for the Admin, for now.

	From a tenant point of ~~you~~, in the DID destination, you need to choose the "Receive an Ademco Alarm report". When the alarm system will dial the number, the system will read the details and write an event entry in Status/Call History - Alarms received		'''From a tenant point of view''', in the DID destination, you need to choose the "Receive an Ademco Alarm report". When the alarm system will dial the number, the system will read the details and write an event entry in Status/Call History - Alarms received

	[[file:alarmsreceived.png\|400px]]		[[file:alarmsreceived.png\|400px]]

			More columns are available, decoding the alarm received.

			From an admin point of view, it is needed to map the caller ID of the alarm system to the tenant. You can do it in Admin/Tenants - Alarms Binding

			[[file:alarmsbinding.png\|400px]]

Admin: Created page with "Asterisk can receive alarms from Ademco compatible devices using the following protocols: Contact ID, Express 4+1, Express 4+2, High Speed and Super Fast. The Asterisk applic..."

2018-09-20T21:55:15Z

Created page with "Asterisk can receive alarms from Ademco compatible devices using the following protocols: Contact ID, Express 4+1, Express 4+2, High Speed and Super Fast. The Asterisk applic..."

New page

Asterisk can receive alarms from Ademco compatible devices using the following protocols: Contact ID, Express 4+1, Express 4+2, High Speed and Super Fast.

The Asterisk application is quite simple and integrating it in a Multitenant PBX was not easy. Unfortunately, the configuration cannot be made from the tenant or maybe, I don't like to have the tenant to mess with this, so the configuration is reserved for the Admin, for now.

From a tenant point of you, in the DID destination, you need to choose the "Receive an Ademco Alarm report". When the alarm system will dial the number, the system will read the details and write an event entry in Status/Call History - Alarms received

[[file:alarmsreceived.png|400px]]

Configuring and using Ademco alarm receiver - Revision history

Admin at 21:57, 20 September 2018

Admin: Created page with "Asterisk can receive alarms from Ademco compatible devices using the following protocols: Contact ID, Express 4+1, Express 4+2, High Speed and Super Fast. The Asterisk applic..."